The fully automatic stubble drying machine adopts two rotors, which makes the crushing of materials more detailed and does not have a mesh size that is easy to block. Even high and low temperature materials that cannot be crushed by old-fashioned stubble cutters can be easily crushed without clogging. The main characteristics are low cost, high production capacity, easy to use crushing, brewery cooling stubble machine, adjustable internal hammer head, total number and parts come from controlling the feed particle size.
The fully automatic stubble drying machine completes the processes of spreading, adding slurry, adding koji, stirring, and unloading in one go. The spreading effect is good, and multiple mixing devices are set up during the spreading process to make the cool stubble loose and not easy to clump during the spreading process. The addition of slurry and koji is uniform, and the quantity can be adjusted. How to use an automatic stubble cooler stably?
1、 Before installation, check all parts of the automatic stubble cooler to see if there are any loose parts. If found, repair is necessary before installation.
2、 When installing, the gap between the stubble machine's running wheel and the track is standardized when the stubble machine runs back and forth with the track.
3、 After the installation of the stubble cutting machine is completed, it is necessary to conduct a trial operation for about five minutes to check for any noise in various parts. If any noise is found, it should be parked for maintenance. After the trial operation is normal, it can be put into normal production and use.
4、 During the use process, it is necessary to regularly pay attention to any abnormal movements and increase the noise. If any noise is found, it should be promptly parked for maintenance.
5、 After the stubble cutting machine is put into use, it should be regularly checked for looseness of bolts and damage to components. If found, it should be repaired or replaced according to the specific situation.
6、 During operation, the oil injection area should be regularly lubricated, usually with butter every three months, to ensure normal lubrication of all transmission parts of the stubble machine and reduce wear.
7、 If the automatic stubble cooling machine is stopped for a long time and put into production again, it should be checked from the beginning and put into production again after the test run is normal.
This article is supported by a fully automatic stubble cooler. For more detailed and exciting content, please click on our website http://www.qfrtrq.com We will wholeheartedly provide you with satisfactory service.