Automatic stubble cooler is a new type of brewing equipment, which has the characteristics of high speed and high efficiency. It can automatically add water, lower the curve, discharge the material, stir evenly, and achieve ideal cooling effect. Each automatic stubble cooler is composed of a crimping device, which is one of the most important devices of the automatic stubble cooler. The bending device is located at the bottom of the automatic stubble cooler, which forms a collection function for the material leakage at the blanking opening, thus saving materials and avoiding waste.
Automatic stubble cooler, including frame, chain plate conveyor belt, automatic bending device, automatic blanking device, reduction motor, material receiving device, mixing device, cleaning device, cooling device, temperature detection device, automatic water adding device, automatic cleaning device, auxiliary platform device, the chain plate conveyor belt is inclined on the frame, and the reduction motor is installed on the frame, The chain plate conveyor belt conveyor line is equipped with automatic blanking device, automatic bending device and material receiving device from bottom to top.
When the automatic stubble cooler is working, a lot of cold water suddenly enters into the water seal groove, forming a negative pressure. Some wineries have good business. Sometimes they need to steam several pots of wine continuously a day. When there is no water in the water seal tank, in order to avoid the evaporation of wine steam, it is necessary to make up the seal water in time. In order to save time, some brewers will add enough cold water to the sealing tank at one time. In fact, this is wrong. The solution is to gradually add cold water to the sealing tank. If you want to reduce the time of encrypting the sealing tank water, you can join the hot water with the same temperature as the existing sealing tank.
If the fan is found to have abnormal sound during operation, the motor is severely heated, and the live switch of the housing trips and cannot be started, the fan shall be stopped immediately for inspection. In order to ensure efficiency, it is not allowed to repair the fan during operation. After maintenance, the trial operation shall be carried out for about minutes, and the machine shall be started up again after admitting that there is no abnormal phenomenon. It can only work when the fan is in full positive gear. At the same time, it is necessary to insist that the capacity of the power supply equipment is met, the voltage is stable, and the lack of phase operation is prevented. The power supply line is necessary to be a special line, and should not be powered by temporary lines for a long time.
What problems will you encounter when the automatic stubble cooler works? The above is the answer to the question. You should remember to check and maintain it in normal use and pay attention to us http://www.qfrtrq.com Learn more!